Veritas Combination Plane - Fluting Blade - PM-V11 corner chisel Please Note: Plane now has

Please Note: Plane now has a Bronze Lever Arm

The Veritas Conversion Kit (Right Hand) for the Veritas Small Plough Plane is used to allow the use of tongue-cutting blades

is not recommended on the side of the wheel where truing is not feasible

01mm/10mm blade length

gouges set at right angles on the end of the tool and are designed to get into areas where a normal full length tool will not fit

Veritas Combination Plane - Fluting Blade - PM-V11 corner chisel Please Note: Plane now hasA Veritas Combination Plane fluting cutter available in sizes: 3 16" (4. 8mm) 1 4" (6. 35mm) 3 8" (9. 5mm) 1 2" (12. 7mm) These blades produce decorative concave fluting on workpieces. To cut flutes, remove the sliding section (and use the small blade guide knob to support the blade). The fluting blade is offset and will be centred on the body skate. Made of PM V11 steel it has a 35 degree bevel angle. PM V11 is highly resistant to dulling or damage